Modules; Attaching Multiple Expansion Modules - Aastra 6753i Installation Manual

Hide thumbs Also See for 6753i:

Table of Contents

Connecting the Expansion Modules to Your Phone

Use the following procedure to connect the Expansion Modules to your 6753i IP phone.

Turn your phone over to show the bottom of the phone.

Turn the expansion module over to show the bottom of the module.

Connect one end of the RJ-45 cable to the RJ-45 port on the back of your phone as indicated in the illustration below.

Connect the other end of the RJ-45 cable to the RJ-45 port on the back of the expansion module as indicated in the

illustration above.

Connector Plate

Screw Holes on

Expansion Module

Back of Expansion

Module

Line up the screw holes on the connector plate with the screw holes on the back of the phone.

Insert the two screws (included with your expansion module) into the connector plate holes and secure to the IP Phone.

Turn over both units to sit face up on the desk with the expansion module sitting flush against the right side of the

phone.

Multiple modules (up to 3 total modules) can be piggy-backed to an IP phone providing an additional 108 softkeys with

M670is. You connect the additional modules to the right side of an existing module. The following figure illustrates the

addition of multiple M670i modules on the 6753i IP Phone.

For more information about setting the softkeys, see the Aastra Model 6753i IP Phone User Guide.

41-001157-06 Rev 03 – 04.2012

Connector Plate

Screw Holes on Phone

RJ-45 Cable

Back of Phone

Model M670i Expansion Modules

Table of Contents