Lh Cylinder Head - Ford Explorer Sport 2002 Workshop Manual

2002 Explorer Sport/Sport Trac Workshop Manual
40. Remove the eight 12 mm (0.47 in) bolts and the two 8 mm (0.31 in) bolts in the sequence shown, and remove the RH cylinder head.
Discard the head gasket.
Discard the cylinder head bolts.
41. Clean the gasket mating surfaces.

LH cylinder head

42. Remove the LH exhaust manifold. For additional information, refer to
43. Remove the LH camshaft chain tensioner.
44. Remove the camshaft sprocket bolt.
45. Remove the chain guide bolt.
46. CAUTION: Remove the camshaft sprocket to prevent breaking the cassette and to gain clearance to remove the cylinder head.
NOTE: Hold the chain and cassette with a rubber band to aid in removal and to prevent the chain from falling into the cylinder block.
Remove the LH camshaft sprocket from the cassette.
47. Remove the eight 12 mm (0.47 in) bolts and the two 8 mm (0.31 in) bolts in the sequence shown and remove the LH cylinder head.
Discard the head gasket.
Discard the cylinder head bolts.
http://www.fordtechservice.dealerconnection.com/pubs/content/~...
Exhaust Manifold LH in this section.
Page 7 of 17
1/22/2010