Both Cylinder Heads - Ford Explorer Sport 2002 Workshop Manual

2002 Explorer Sport/Sport Trac Workshop Manual
12. Tighten the eight 12 mm (0.47 in) bolts in two stages in the sequence shown.
Stage 1: Tighten the bolts 90 degrees.
Stage 2: Tighten the bolts an additional 90 degrees.
13. Install the RH camshaft sprocket in the cassette.
14. CAUTION: The camshaft sprocket must turn freely. DO NOT tighten the bolt.
Install the RH camshaft sprocket bolt.
15. Position the bracket and install the bolt.
16. Position the ground strap and install the bolt.
17. Install the RH exhaust manifold. For additional information, refer to

Both cylinder heads

18. CAUTION: The RH sprocket bolt in a left-hand threaded bolt.
NOTE: Use the Camshaft Gear Torque Adapter (303-565) to loosen the camshaft sprocket bolt.
If necessary, loosen the RH camshaft sprocket bolt.
http://www.fordtechservice.dealerconnection.com/pubs/content/~...
Exhaust Manifold — RH in this section.
Page 10 of 17
1/22/2010