Hardware Interface Configuration; C-Bus; Lon-Bus - Honeywell XI581AH User Manual

XI581/2 BUSWIDE OPERATOR INTERFACE

Hardware Interface Configuration

5. From the second screen of the Start-up Sequence (shown above), select
Controller Setup and press Enter (↵).
RESULT: A screen appears with a list of hardware interface configuration
options.
HW-Interface Configuration

C-Bus

Lon-Bus

B-Port
The contents of this listbox will depend upon the exact hardware configuration of the
controller.
6. Select a hardware interface and press Enter (↵) to continue.
If C-Bus is selected from the 'Hardware Configuration' listbox, the following screen
appears:
C-Bus Configuration
Baudrate :
Controller No.:
7. The 'Baudrate' value field is highlighted by default. Or use the down arrow key to
move to and highlight the 'Controller No.' value field. In either case, after
pressing Enter (↵) to select the given field, one of the digits will begin blinking.
Use the plus and minus keys to increment/decrement data, and press Enter (↵)
to complete the field entry.
IMPORTANT
If no controller number is set or if the number shown is not reconfirmed, the
controller will not go online on the C-Bus after start-up.
8. Use the right arrow key to move to and highlight BACK. Press Enter (↵).
If LON-Bus (i.e. L W
ON ORKS
listbox, the following screen appears:
LON-Bus Configuration
Contr. Neuron ID: ACF123BDE789
The Neuron ID is the unique number assigned to the controller's processor and
cannot be edited.
7. Press Enter (↵) to select BACK.
35
L L L L
1
I
76800
23
BACK
network) is selected from the Hardware Configuration
BACK
EVERYDAY OPERATIONS
C-Bus
LON-Bus
EN2B-0126 (74-3554-8)