Enabling/Disabling Buswide Alarm Mode And Alarm Flag - Honeywell XI581AH User Manual

XI581/2 BUSWIDE OPERATOR INTERFACE
Access Level
Procedure 1. From the Main Menu, use the arrow keys to move to and highlight Alarms. Then
press Enter (↵) to complete the selection.
RESULT: The 'View Alarms' screen displays.
2. Use the arrow keys to move to and highlight Buswide Access. Then press
Enter (↵) to complete the selection.
RESULT: The display window lists all devices available for log-in. Controller
Buswide Alarms
Name
CONTROLLER_07
CONTROLLER_09
3. Press the arrow keys to move to and highlight the desired controller. Then press
Enter (↵) to complete the selection.
RESULT: You are now logged into the alarm buffer of the selected remote
4. View the alarm buffer using the same procedure as for a local controller. See
section "Viewing Alarm Information" (page 21) for details if you do not know
how. When you are through reading the buffer, log off the remote controller
(press Cancel repeatedly).
RESULT: Software removes the controller number character from the alarm
Purpose To set up XI581/2 so that it displays the alarm flag, !, when new buswide alarms
occur.
All users can perform this task.
Procedure 1. From the Main Menu, use the arrow keys to move to and highlight System
Data. Then press Enter (↵) to complete the selection.
RESULT: The display window show system data, including the 'Buswide
System Data
View Alarms
Alarm Buffer
All Points in Alarm
Critical Points in Alarm
Non Critical Points in Alarm
Buswide Alarms
name and number as well as alarm status information list for each
device. The number of the controller appears below 'No'. An 'x'
appears below an alarm header (Critical or Non Critical) to indicate
the presence of an alarm.
No Crit
7 x
9 x
controller.
buffer to indicate that the alarm(s) were viewed.

Enabling/Disabling Buswide Alarm Mode and Alarm Flag

Access' option.
System Info
HW-Interface Config.
Flash EPROM
Buswide Access
23
EVERYDAY OPERATIONS
Non Crit
L L L L
x 1
I
M
EN2B-0126 (74-3554-8)