Specifications - Evinrude E-Tec Operator's Manual

Product Information
Displacement
Engine Type
Full Throttle Operating
Range
(1)
Power
(2)
Idle RPM in Gear
Idle RPM in Neutral
(2)
Ignition Timing
Emission Control System:
(2)
per SAE J1930
Fuel Requirements
Oil – Lubricant
– Capacity
Warning Signals
Battery, Minimum
(2)
Spark Plug
Fuses
Fuel Filter
Battery Charging
Gearcase – Lubricant
– Capacity
Power Trim/Tilt – Fluid
Capacity
Propeller
Weight
Sound at Driver's Ear
(LpA) ICOMIA 39.94
Transom Height
(1) Rated following the standards of ICOMIA 28.83, ISO 3046 and NMMA.
(2) Emission Control Information.
48

SPECIFICATIONS

40, 50, 60 Models
52.7 cu. in. (864 cc)
In-line, 2 Cylinder, Two-Cycle, E-TEC
40 HP – 5000 to 6000 RPM
50 HP – 5500 to 6000 RPM
60 HP – 5500 to 6000 RPM
40 HP – 40 HP (29.8 kw) @ 5500 RPM
50 HP – 50 HP (37.3 kw) @ 5750 RPM
60 HP – 60 HP (44.7 kw) @ 5750 RPM
850 ± 50
(2)
750 ± 50
Not Adjustable
ECM, E-TEC (Engine Control Module, E-TEC )
(2)
87 Pump Posted AKI (90 RON) – Refer to Oil and Fuel on
page 17
TC-W3RL NMMA-certified oil or Evinrude/Johnson XD100 oil
– Refer to Oil and Fuel on page 17
2.0 qt. (1.9 l)
Controlled by the outboard's EMM
640 CCA (785 MCA) 12 volt
Refer to ECI Label
Refer to Fuse on page 33
In-line Replaceable
25-Amp, Fully Regulated
Evinrude Ultra-HPF ™
L Models – 22 fl. oz. (650 ml)
11.7 fl. oz. (345 ml)
Refer to Propeller Selection on page 44
L Models – 240 lbs. (109 kg)
76.8 dB(A)
L Models – 19 1/2 to 20 in. (495 to 508 mm)