Oil And Fuel - Evinrude E-Tec Operator's Manual

OILING SYSTEM
If the "LOW OIL" warning light illuminates,
you have approximately five hours of normal
operation before running out of oil when us-
ing TC-W3RL oil. If using Evinrude/Johnson
XD100 ™ oil, you have approximately ten
hours of normal operation remaining. Refill
the onboard oil tank at next convenient op-
portunity. Refer to Priming the Oiling Sys-
tem on page 17.
IMPORTANT: Always "top off" your oil tank
prior to prolonged usage or long trips.
FILLING THE OIL TANK
Release the port and starboard engine cover
latches by turning each handle downward.
Pull up on the tilt handle to release the engine
cover seal on the engine cover.
1
1. Tilt handle

OIL AND FUEL

Remove the engine cover to access the oil
tank.
Remove the filler cap and fill the tank with the
recommended outboard lubricant, as speci-
fied in Oil Requirements on page 18.
Replace the filler cap and tighten securely.
Reinstall the engine cover.
IMPORTANT: The oil tank capacity is 2.0
quarts (1.9 liters).
PRIMING THE OILING SYSTEM
The oiling system must be primed before re-
using the outboard if:
• You run completely out of oil; or
• The outboard is laid down for transportation
or storage.
Prime the oiling system by performing winter-
ization. Refer to Long-Term (Winterization)
on page 39.
O F
IL AND UEL
17