Evinrude E-Tec Operator's Manual page 55

Product Information
Manufacturer's Limited Warranty Coverage
This emission limited warranty covers Evinrude outboards certified and produced by BRP for sale in Califor-
nia, that are originally sold in California to a California resident, or subsequently warranty-registered to a Cal-
ifornia resident. The BRP U.S. and Canada limited warranty conditions for Evinrude outboards are still
applicable to these models with the necessary modifications.
Select emission control parts of your Evinrude E-TEC outboard are warranted from the date of purchase by
the first retail consumer or the date the product is first put to use, whichever occurs first, for a period of: 4
years, or for 250 hours of use, whichever occurs first.
However, warranty coverage based on the hourly period is only permitted for outboards equipped with the
appropriate hour meters or their equivalent. If any emission-related part on your engine is defective under
warranty, the part will be repaired or replaced by BRP.
Parts covered are:
1. Electrical System
A. EMM (Engine Management Module)
B. Spark Plugs and Wires
C. Ignition Coils
D. Wiring Harness
2. Exhaust System
A. Inner Exhaust Housing
B. Adaptor (Exhaust Manifold)
3. Fuel System
A. Fuel Lift Pump
B. Fuel Supply Pump
C. Fuel Injectors
D. Vapor Separator
E. Fuel Lines, Fittings, and Clamps
The emission warranty covers damage to other engine components that is caused by the failure of a warrant-
ed part.
The BRP Operator's Guide provided contains written instructions for the proper maintenance and use of your
outboard. All emission warranty parts are warranted by BRP for the entire warranty period of the outboard,
unless the part is scheduled for replacement as required maintenance in the Operator's Guide.
Emission warranty parts that are scheduled for replacement, as required maintenance, are warranted by BRP
for the period of time before the first scheduled replacement date for that part. Emission warranty parts that
are scheduled for regular inspection but not regular replacement are warranted by BRP for the entire warranty
period of the outboard. Any emission warranty part repaired or replaced under the terms of this warranty
statement is warranted by BRP for the remainder of the warranty period of the original part. All parts replaced
under this limited warranty become the property of BRP.
Maintenance receipts and records should be transferred to each subsequent owner of the outboard.
Owner's Warranty Responsibilities
As the outboard owner, you are responsible for the performance of the required maintenance listed in your
Operator's Guide. BRP recommends that you retain all receipts covering maintenance on your outboard, but
BRP cannot deny warranty solely for the lack of receipts or your failure to ensure the performance of all sched-
uled maintenance.
As the outboard owner, you should however be aware that BRP may deny you warranty coverage if your out-
board or a part has failed due to abuse, neglect, improper maintenance, or unapproved modifications.
You are responsible for presenting your outboard to an authorized BRP dealer as soon as a problem exists.
The warranty repairs will be completed in a reasonable amount of time, not to exceed 30 days.
For any questions regarding your warranty rights and responsibilities or for the name and location of the near-
est authorized BRP dealer, contact Bombardier Recreational Products Customer Support Services, 250 Sea
Horse Drive, Waukegan, IL 60085, 1-847-689-7090 or visit www.evinrude.com.
52
4. Air Induction System
A. Reed Valves
B. Throttle Body Assembly
C. Intake Manifold
5. Oil System
A. Oil Injector
B. Oil Lines, Fittings, and Clamps
6. Sensors
A. Air Temperature Sensor
B. Crank Position Sensor
C. Throttle Position Sensor
D. Water Temperature Sensor
E. Thermostat
7. Gaskets
A. All Emission Component Gaskets