Specifications - Evinrude E-TEC Operator's Manual

Product Information
Displacement
Engine Type
Full Throttle Operating
Range
(1)
Power
(2)
Idle RPM in Gear
Idle RPM in Neutral
(2)
Ignition Timing
Emission Control System:
(2)
per SAE J1930
Fuel Requirements
Oil – Lubricant
Warning Signals
(3)(4)
Battery, Minimum
(2)
Spark Plug
Fuses
Fuel Filter
Battery Charging
Gearcase – Lubricant
– Capacity
Power Trim/Tilt – Fluid
– Capacity
Propeller
Weight
Sound at Driver's Ear
(LpA) ICOMIA 39.94
Transom Height
(1) Rated following the standards of ICOMIA 28.83, ISO 3046 and NMMA.
(2) Emission Control Information.
(3) Use a 750 CCA (940 MCA) battery when operating in temperatures below 32°F (0°C).
(4) Under extraordinary electrical load or environmental conditions, use a 107 amp-hour minimum battery
(generally available in group 29 size).
46

SPECIFICATIONS

115, 130 Models
105.4 cu. in. (1727 cc)
60° V, 4 Cylinder, Two-Cycle, E-TEC
115 HP – 5500 to 6000 RPM
130 HP – 5500 to 6000 RPM
115 HP – 115 HP (85.8 kw) @ 5750 RPM
130 HP – 130 HP (96.9 kw) @ 5750 RPM
500 ± 50
(2)
500 ± 50
Controlled by the outboard's EMM
ECM, E-TEC (Engine Control Module, E-TEC)
(2)
87 Pump Posted AKI (90 RON) – Refer to Oil and Fuel on
page 17
Evinrude/Johnson XD100 oil or TC-W3RL NMMA-certified oil
– Refer to Oil and Fuel on page 17
Controlled by the outboard's EMM
675 CCA (845 MCA) 12 volt or
750 CCA (940 MCA) 12 volt below 32°F (0°C)
Refer to ECI Label
P/N 967545 – Refer to Fuse on page 30
P/N 502906
50-Amp, Fully Regulated, Dual Isolated
Evinrude Ultra-HPF™
L Models – 33.1 fl. oz. (980 ml)
X Models – 44 fl. oz. (1300 ml)
Evinrude/Johnson Power Trim/Tilt and Power Steering Fluid
21 fl. oz. (622 ml)
Refer to Propeller Selection on page 42
L Models – 375 lbs. (170 kg)
X Models – 390 lbs. (177 kg)
79.0 dB(A)
L Models – 19 1/2 to 20 in. (495 to 508 mm)
X Models – 24 1/2 to 25 in. (622 to 635 mm)