Programming The Circulation Pump Filtration Cycle - Sundance Spas 780 series Owner's Manual

780 SERIES
Economy Filtration/Heating Modes
F4 1 hour of filtration/heating per day (one 30-minute cycle
every 12 hours)
F5 1.5 hours of filtration/heating per day (one 30-minute
cycle every 8 hours)
F6 2 hours of filtration/heating per day (one 30-minute cycle
every 6 hours)
Lock Modes
L1 Lock Out (disables all spa functions to permit filter
cleaning)
L2 Lock Mode (disables the jets to prevent unauthorized
use of spa). Filtration/heating cycle will continue to
operate as programmed in this mode. The temperature
display flashes when this function is enabled. Example:
the "F3" filtration/heating cycle was enabled prior to
choosing lock mode. The spa continues to perform the "F3" cycle
until lock mode is canceled, allowing another cycle to be selected.
Note: To exit a lock mode you will need to re-enter the filtration/heating
modes and select a new cycle from F1-F6.
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire your
first filtration/heating cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM.
Note: Start time is approximate and may vary slightly from day to day.
10.5

Programming the Circulation Pump Filtration Cycle

Press and hold the Jets pump 1 (
same time for 3 seconds to access the circulation pump programming.
Continually press the Warmer (
below. Then select a cycle and press the Jets pump 1 (
activate that cycle. Upon pressing the jets pump 1 button the system will
save your selection, exit the program menu and return to the main menu.
Note: After 10 seconds the programming screen will revert back to the
temperature if no buttons are pressed. You cannot have more than one
circulation pump cycle activated at a time.
Page 30
) and Cooler (
1
) button to scroll up through the cycles
) button at the
) button to
1