Table of Contents
Advertisement
cartridge 1. Hold your garden hose over the filter cartridgte 1 wall fit-
ting (with grate) while using a rag as a seal around hose end. Ask a
helper to turn on water for 30 seconds, then turn off. Reinstall filter
cartridge 1 and check spa (sec. 11.1, page 25).
4. If problem persists, contact your authorized Sundance dealer.
13.8 Panel Displays ICE
Freeze Protection - A potential freeze condition has been
detected. No action is required. Jets pump 1, circulation pump
(if equipped) and heater will operate to circulate and warm water
through the plumbing spa is out of danger. See "Winterizing"
section 11.7 for details (page 28).
13.9 Panel displays - - -
The safety "Watchdog" software has been triggered and the
spa is deactivated. A problem has been detected which could
cause damage to the spa or its components. Contact your
authorized Sundace dealer.
14.0 Troubleshooting Procedures
In the event your spa is not working the way it should, please first review
all the installation and operating instructions in this manual and check the
message on the panel display. If you are still not satisfied it is working
properly, please follow the appropriate troubleshooting instructions. Note:
If any of the supply cords to the accessories are damaged, they must be
replaced by an authorized Sundance service technician.
14.1 None Of The Components Operate (e.g. Pump, Light)
Check the following when none of the spa components operate
(e.g. jets pumps or light):
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Contact your authorized Sundance dealer.
14.2 Pump Does Not Operate But Light Does
Press the JETS Button:
1. If no water movement is detected, make sure power is going to the
spa and check the water level. If it does not solve the problem, con-
tact your authorized Sundance dealer.
2. The main jets pump 1 operates but no water flows to jets. Check the
following:
Page 32
Hide quick links:
Advertisement
Table of Contents
