Minimum Flow Adjustment For Hob Gas Taps - Baumatic BHG300SS User Manual

Kind of gas
Natural
L.P.G.
Butane
Propane
o Reassemble all the burners carefully; in particular you should
make sure that the flame spreader is correctly placed on the
burner.
o IMPORTANT: The minimum flow adjustment process must
be completed before the appliance is next used.

Minimum flow adjustment for hob gas taps.

All work
registered engineer.
IMPORTANT: Always isolate the hob from the electricity supply
before changing the injectors and/or adjusting the minimum
flow of the burners.
tighten the adjusting screw to decrease the gas flow.
o The correct adjustment is obtained when the flame has a
length of about 3 – 4 mm.
o For butane/propane gas, the adjusting screw must be tightly
screwed in.
o Refit the control knob.
GENERAL INJECTORS TABLE
Nozzle Burners
mm/100
115 Rapid
72 Auxiliary
85 Rapid
50 Auxiliary
must be carried
Power (in watts)
Max. Min.
3000 750
1000 300
3000 900
1000 370
out by a GASSAFE
o Switch the burner on
and set the knob at the
minimum position.
o Remove the knob from
the tap and place a
small bladed
screwdriver in the
centre of the tap shaft.
o Unscrew the adjusting
screw, in order
increase the gas flow or
to
20