Minimum Flow Adjustment For Hob Gas Taps - Baumatic Pythagora P62SS Instruction Manual

Minim m u flow adjustment for hob gas taps.
All work must be carried out by a
e ngineer.
IMPORTANT: Always isolate the hob from the electricity supply
before changing the injectors and/or adjusting the minimum
flow of the burners.
o Unscrew the adjusting screw, in order to increase the gas flow
or tighten the adjusting screw to decrease the gas flow.
The correct adjustment is obtained when the flame has a
o
length of about 3 – 4 mm.
For butane/propane gas, th
o
screwed in.
Refit the con
o
o Make sure that the flam
from maximum flow to minimum flow. If it does then remove
the control knob and make further adjustments to the gas
flow, testing it again once the adjustment has been made.
Repeat this process for each one of the gas taps.
o
e adjusting screw must be tightly
trol knob.
e does not go out by quickly turning
CORGI registered
o Switch the burner
on and set the
knob at the
minimum
position.
Remove t he knob
o
from the tap and
place a small
bladed
screwdriver in
centre o f the tap
shaft.
the
21