Post Inserter; Keys On Control Panel - Olivetti d-Color MF451 Instructions Manual

5.1 Basic
Settings
Position Setting
5.1.6

Post Inserter

When the Post Inserter PI-505 is installed on the Finisher FS-526, you can manually operate the Finisher
FS-526 using the post inserter control panel.
Reference
- Only the lower tray can be used as the output tray. The upper tray is not available.

Keys on control panel

No. Name
1 Corner staple lamp
2 Center staple & fold lamp
3 [Finishing] key
4 2-hole lamp
5 3-hole lamp
6 [Select punch] key
7 [Start/stop] key
8 4-hole lamp
9 Tri-fold lamp
10 2 position staple lamp
d-Color MF651/551/451
Configure desired staple or hole-punch positions.
Select Auto, and the machine automatically judges the staple or punch posi-
tions for the paper relative to the original direction loaded.
• A staple or hole-punch position is set along the long side of the paper if the
original length is 297mm or less.
• Staple or hole-punch positions are set along the short side of the paper if
the original length is more than 297mm.
• Staple or punching positions are set on the upper or left-side end.
• Be sure to load the original so that its top side is placed in the back.
• If desired, press [Original Direction], and then select the original direction.
5
5-13