Honda CBR1100XX EFI Installation Manual page 27

NOTE: - You will have suitable terminals and housings to make all connection on the bike without
cutting any wires on the bike. Alternatively, you can connect the wires using your own methods. We
would recommend that you solder the wires together rather than use 'Quick Tap' type wire connectors,
however quick tap connectors are provided in the kit.
Brake light switch connection.
•
Route the brake connection wires to the right side of the bike, across the front of the fuse box and the other
electrical boxes. The rear brake light switch plugs are all mounted behind the battery.
•
Locate the rear brake switch connector plug. This is
under one of the relays that are mounted under the battery.
Pull the relay up off its mounting to find the plug. If you
are not certain which connector to use, follow the wire up
from the rear brake light switch.
•
The white/green wire provides power to the brake system and is used to provide power for the cruise
control. It must have the orange brake/power wire from the cruise control connected to it. This connection
must have 12V present at all times.
•
The green/yellow wire goes to the brake light and is used to provide brake sensing for the cruise control. It
must have the grey brake sensor wire from the cruise control connected to it. This connection must have
12V present ONLY when the brakes are operated. If you have disconnected the plug, operating the REAR
brakes will not work, however operating the FRONT brakes will apply 12V to this wire.
•
The wires from the brake light switch are both black.
•
Route the orange and grey brake sensor wires to the rear brake light switch plug. Cut the wires to a suitable
length to reach the brake light switch plug.
•
In this installation the brake sensing branch will have to be about 85cm (34") long.
•
You may use the following instructions to make the connection.
•
Crimp or solder the wires to the terminals provided and make up a 'patch' connection as shown. Use some
of the excess orange and grey wire from the cruise control loom for the link wires.
Honda CBR1100XX EFI – all models ©
27