Honda CBR1100XX EFI Installation Manual page 16

•
Route the control switch wire down the front of the fluid
reservoir, between the fluid reservoir and the handle bar.
Route the wire down and around the front and to the
inside of the fork tube with the clutch fluid hose.
•
Route the wire up with the brake fluid pipes and across to
the right side of the bike, UNDER the throttle cables and
under the air filter snorkel.
•
Make sure that there is sufficient length in the wire to
prevent the wire being pulled tight during steering
movement and apply two small cable ties to the brake
lines where circled in the photos.
•
Route the wire around the outside of the frame on the
right side, and down and inside the frame with the coolant
hose (see the circled are in the photo).
•
Route the wire up the inside of the frame to the brake
lines and back with the brake lines. Cable tie the wire to
the brake lines where indicated. Cable tie the
ACTUATOR CABLE to the brake line too.
Honda CBR1100XX EFI – all models ©
•
Cable tie the wire to the fairing mount as shown.
16