Honda CBR1100XX EFI Installation Manual page 22

•
In the event of a wire pulling out and leaving the terminal
inside the plug, a paper clip or any piece of wire up to
1mm (0.040") can be used to push the terminal out. DO
NOT USE WIRE LARGER THAN 1mm DIA.
•
In order to attach the terminals to the wire you will either need a suitable 'roll crimp' crimper or a small 15
~ 60 watt electronic soldering iron and a fine tip.
•
A crimper of this type is suitable for crimping these
terminals, but it MUST have small crimping jaws, about
half the size usually found on most aftermarket automotive
crimpers. The one shown is an Utilux No. 47A. An Utilux
No. 147A is also suitable.
NOTE: - Crush crimpers are NOT suitable for use on
these terminals.
•
Use the smallest jaw with the roll crimp to crimp the wire
bucket on the terminal, and the largest jaw with the round
crimp to crimp the insulation bucket.
Honda CBR1100XX EFI – all models ©
•
You can then cut the wire to the correct length and re-
terminate the wire with one of the computer plug terminals
provided in the kit. You should have a strip of 20 of these
terminals in the kit.
22