Honda CBR1100XX EFI Installation Manual page 18

•
Push the short length of the vacuum hose onto the vacuum
hose fitting.
•
Route the hose as shown in the photo. The purpose of the
routing is to keep the hose elevated to prevent fuel
pooling in the hose at any low points.
•
Attach the free (long) end of the hose to the hose barb on
the vacuum actuator.
Mounting the computer.
•
Cut the foam block [supplied] to fit the rear compartment. We have supplied the drawing below for
suggested dimensions to cut to. The foam block can be cut very cleanly by a sharp, long-bladed knife such
as a carving knife. Utility (Stanley) knives don't cut foam very cleanly.
Honda CBR1100XX EFI – all models ©
18