Honda CBR1100XX EFI Installation Manual page 24

7 No connection
6 Control switch ground - green/black
5 Control switch back light - brown/black
4 Power in from fuse - pink
3 No connection
2 Control switch engage light - grey/black
1 Control switch On/Off - orange/black
14 Control switch Set/Res - yellow/black
15 Clutch/neutral sensor - blue
16 Ground - black
17 No Connection
18 Control switch ON-OFF light red/black
19 Power & brake sensor supply - orange
20 Brake sensor ground - grey
WARNING: - It is CRITICAL that the correct wires go into the correct holes, both for safe operation of
the cruise control and to ensure that the cruise control circuitry is not damaged.
•
Insert the terminal into the appropriate hole in the plug.
The terminal must be inserted all the way into the plug as
shown. The holes circled show one hole with the terminal
inserted properly and another without complete insertion.
Honda CBR1100XX EFI – all models ©
1 5 9
14 18 22
•
If you cannot get the terminal to push home by pushing
the wire (the wire bends while pushing in the terminal),
you can use the end of a paper clip or a jeweller's
screwdriver to push on the end of terminal by sliding it
past the seal next to the wire and pushing the terminal
home.
24
8 Actuator solenoid power - red
9 Actuator vacuum solenoid - yellow
10 No connection
11 No connection
12 No connection
13 Speed sensor ground - used
ONLY when connected to the
bikes speedometer sender
- black co-ax shield
13
26
26 Tach sensor - yellow
25 Inductive speed sensor ground - black co-ax shield
24 Speed sensor active - blue co-ax
23 Actuator safety dump solenoid - brown
22 Dump solenoid - green
21 No connection