Safety Information & Recommended Training For Radio Controlled Equipment Operators - Magnetek Enrange CAN-6 Instruction Manual

2.3 SAFETY INFORMATION & RECOMMENDED TRAINING FOR RADIO CONTROLLED
EQUIPMENT OPERATORS
Anyone being trained to operate radio controlled equipment should possess as a minimum the following
knowledge and skills before using the radio controlled equipment.
The operator should:
 have knowledge of hazards pertaining to equipment operation
 have knowledge of safety rules for radio controlled equipment
 have the ability to judge distance of moving objects
 know how to properly test prior to operation
 be trained in the safe operation of the radio receiver as it pertains to the crane, hoist, lifting device or
other material handling equipment being operated
 have knowledge of the use of equipment warning lights and alarms
 have knowledge of the proper storage space for a radio control receiver when not in use
 be trained in transferring a radio control receiver to another person
 be trained how and when to report unsafe or unusual operating conditions
 test the receiver emergency stop and all warning devices prior to operation; testing should be done
on each shift, without a load
 be thoroughly trained and knowledgeable in proper and safe operation of the crane, hoist, lifting
device, or other material handling equipment that utilizes the radio control
 know how to keep the operator and other people clear of lifted loads and to avoid "pinch" points
 continuously watch and monitor status of lifted loads
 know and follow cable and hook inspection procedures
 know and follow the local lockout and tagout procedures when servicing radio controlled equipment
 know and follow all applicable operating and maintenance manuals, safety procedures, regulatory
requirements, and industry standards and codes
The operator shall not:

lift or move more than the rated load

operate the material handling equipment if the direction of travel or function engaged does not
agree with what is indicated on the controller

use the crane, hoist or lifting device to lift, support or transport people

lift or carry any loads over people

operate the crane, hoist or lifting device unless all persons, including the operator, are and remain
clear of the supported load and any potential pinch points

operate a crane, hoist or lifting device when the device is not centered over the load
Enrange CAN-6 Instruction Manual
September 2011
Page 6 of 24