Signal Strength/Error Code Led (Bottom Led On Can-6 Faceplate) - Magnetek Enrange CAN-6 Instruction Manual

5.3.2

Signal Strength/Error Code LED (Bottom LED on CAN-6 Faceplate)

Solid Green = Good RF signal strength to transmitter
Solid Red = Poor RF signal strength to transmitter
Blinking Red = Error (code is picked up from number of blinks)
Refer to Section 6.0 for the troubleshooting table to interpret error codes.
NOTE: SIGNAL STRENGTH/ERROR CODE LED only illuminates green when the receiver is
online with the transmitter. The SIGNAL STRENGTH/ERROR CODE LED will not illuminate
green after the transmitter goes offline from the receiver. This can occur when the transmitter
powers down from inactivity or goes out of range. The START toggle on the transmitter must be
toggled to bring the transmitter back online with the receiver.
Red 2 Blinks - Commanded Power Down
Red 3 Blinks - RF Data Timeout
Red 4 Blinks - CANbus Timeout
Enrange CAN-6 Instruction Manual
September 2011
Page 21 of 24