Wideye SABRE I User Manual page 71

g. Warning
i. Do not place the battery into the microwave oven or heating container.
ii. Do not use the battery pack in event that it sends out peculiar smell, generates heat, goes out
of shape, changes color or other unusual phenomena.
iii. Move the battery pack away from the fire when it leaks or when it emits peculiar smell.
iv. The electrolytic liquid that has leaked out might cause an explosion or might be a fire hazard.
v. In the event that the electrolytic liquid that leaks out from the battery pack enters into the eyes,
do not wipe or rub your eyes. Wash it by water and seek medical rescue immediately. Any delay
may cause injury to the eyes.
vi. The battery pack shall not be exposed to temperature above 60 °C. Conditions that will result
in this will be in areas such as in a car that is parked under the Sun or under direct sunlight.
Conditions such as these will cause the battery pack to over heat or may even cause a fire. This
will affect the performance of the battery pack and shortens its cycle life.
vii. For battery pack storage that spans more than three months there is a need to keep the battery
at 50% of the specified capacity. The battery pack must be charged once in three months. It
should be stored in cool dry surroundings with a temperature range of between -20°C to 50°C.
The following are to be avoided: corrosive material, fire source and heat source.
viii. When the battery pack is used by children, please kindly supervise them according to the content
of the manual.
ix. In the event of a battery leakage, and the electrolytic liquid come into contact with the skin or
clothes, wash the affected area with water immediately. Any delay may result in the inflammation
of the skin.
5.5 SB1/AMC10 In-Vehicle Charger
Output end of the In-Vehicle Charger is to be
attached to the power inlet of SABRE™ I.
Photograph of an In-Vehicle Charger.
FIGURE 5.6-1: Illustration exemplifying the features and application of the
In-Vehicle Charger for use with SABRE™ I.
I. Operation
a) Plug the input of the In -Vehicle Charger (as per Figure 6-1) into the cigarette lighter in the car.
b) The In -Vehicle Charger accepts an input voltage of 12 V to 24 V and produces an output voltage of 15 V,
2A at the output terminal.
c) Plug the output of the In - Vehicle Charger into the power inlet of SABRE™ I. Power to charge the internal
battery of SABRE™ I will be supplied by the car via the In -Vehicle Charger.
This portion attaches to the input of a standard
car cigarette lighter
Photograph of an In-Vehicle Charger showing the
portion that attaches to the input of the standard
vehicle cigarette lighter.
68