Configuring The Sabre™ I For Network Access; (Via Built In Lcd Interface)-(Configuring For Standard Connection) - Wideye SABRE I User Manual

4.4.2 Using the Bluetooth Headset
I. Perform the pairing and connection procedures
before proceeding with this section. (Enabling
Bluetooth on SABRE™ I, Bluetooth device pairing
and connection procedures are found in Section
4.3 Bluetooth Settings on SABRE™ I.)
II. Making phone calls directly –
a. Bluetooth Handset: Enter the calling party
number in the following format: <00><Country
Code><Telephone Number><#> (Calling
numbers will be displayed in the LCD).
b. Press the
sequence.
III. Making phone calls via Bluetooth Handset.
(Please refer to Appendix 6 of the Accessories
User Guide.)
4.5 Configuring SABRE™ I for network access
(via built in LCD Interface)-( Configuring for Standard Connection)
4.5.1
Ethernet settings on
4.5.1.1 Change to Bridge mode:
I. From the LCD, use the Up/Down buttons to select Menu > Settings > Interfaces > Ethernet >
Connectivity > Bridge Mode Connection and Press ENTER
II. Use the Up/Down buttons to select Enable and Press ENTER.
4.5.1.2 Proceed with the following steps to activate a Data connection:
I. From the PC, open DUN Client - double-click on the DUN Client icon.
Note: There is a standard primary profile, cid = 1, as default configuration.
II. Click Dial to start connection. Username and Password are not required.
III. Wait until connection is successful, open the Internet Browser to begin "Surfing".
button to start the dialing
SABRE™ I -
Bridge (TAF) Mode
FIGURE 4.4.2-1: Figure showing the wireless connectivity
of the Bluetooth Handset with SABRE™ I.
38