Wideye SABRE I User Manual page 23

3.6.1.1.1.3 Installing Device Drivers
I. After successful completion of LaunchPad installation, the installer will take you to the next step to install the
SABRE™ I Ethernet Serial Device Driver. This driver is required for the Terminal to operate in "Bridge" mode.
If your PC/Laptop is built-in with Dual Core CPU, then you MUST NOT install the Device Driver and click on the
"Cancel" button to cancel the Device Driver installation. Otherwise, please proceed to the next step.
II. If an existing installation of the Device Driver is detected, the installer will prompt the user to uninstall the
existing Device Driver before installing the new driver. Click on "Yes" to proceed.
X. During the installation process, you may be prompted warning messages as shown below. Please ignore the
messages and click on the "Continue Anyway" button to continue.
20