Wideye SABRE I User Manual page 17

IV. For subsequent use, the SABRE™ I will not acquire
a new GPS, it will prompt the user if the previously
stored GPS coordinates should be used.
To use the stored GPS coordinates, use the
Up/Down buttons to select Yes and press ENTER.
A indicator will indicate the use of the stored
GPS
GPS coordinates.
To re-acquire a new GPS, select No and press
ENTER. SABRE™ I will repeat Step I to III.
V . Press the ENTER button and the LCD will show the
signal strength bar.
3.4.4 Antenna Pointing
I. SABRE™ I is now in Antenna Pointing state.
To obtain the maximum possible signal strength,
I I .
adjust the antenna by turning and tilting it. For
an acceptable service to commence, a signal
strength of minimum 45 dBHz is required. Press
ENTER when the maximum possible signal
strength is obtained.
III. SABRE™ I will start the registration with the network.
IV. When registration is successful, the service
provider's name will be displayed.
FIGURE 3.4.3-4: LCD display indicating the system's
query to user if user would like to use the stored
GPS coordinates.
FIGURE 3.4.3-5: LCD display indicating the Signal
Strength Bar
Location of
Antenna
FIGURE 3.4.4-1: SABRE™ I exhibiting two degrees of
freedom to enable adjustment for optimum signal
strength.
FIGURE 3.4.4-2: LCD display indicating that the
SABRE™ I is in the state of Network Registration.
FIGURE 3.4.4-3: LCD display indicating the "Ready
State" of SABRE™ I. In this state, the terminal is
ready for On Air deployment.
14