Wideye SABRE I User Manual page 70

1) Connect the Secondary Battery Pack to the output cable according to the above setup.
2) Connect the Converter Tip with the output cable.
3) Plug the DC OUT end of the cable into the DC OUT jack of the battery pack.
4) Plug the Converter Tip into the DC Input of SABRE™ I.
5) The Secondary Battery Pack begins to supply power to SABRE™ I.
iii. When the micro switch "Power" button is pressed, the system will indicate the amount of power
that still remains for four seconds.
0% ≤ Remaining Power ≤ 20%
20% ≤ Remaining Power ≤ 40%
40% ≤ Remaining Power ≤ 60%
60% ≤ Remaining Power ≤ 80%
80% ≤ Remaining Power ≤ 100% 5 LED
Note: When the LED light is flicking, the remaining power is less than 10% or the voltage of the
battery pack is lower than 10.3V. The power inspecting system will not consume the battery's power
when the button "POWER" is not pressed.
c. Product specifications
i. Weight: About 770g
ii. Chemistry: Lithium Polymer
iii. Charging Input: 16V, 4.5 A by AC adaptor
iv. Output Voltage: 16V
v. Output current: ≤ 3.5A
vi. Maximum Output Power: 60 W
vii. Charging Time: About 4 ~5 Hours
viii. Output Capacity: 66.6Wh / 6000mAH
ix. Cycling life: at least 300 times. Life is terminated when its discharging capacity is less than
80% of the nominal capacity for 3 consecutive times.
x. Dimension: 230 X 165 X 15 mm.
d. Accessories
i. 1 AC Adaptor Set (Power cord and Power adapter)
ii. 1 Output cable (Secondary Battery Pack supply outlet and converter tip)
iii. 1 User Manual
e. Safety Notice
Battery leakage and explosion preventive measures:
f. Danger
i. Do not immerse the battery pack in water, seawater or expose it to excessive moisture.
ii. Do not use, expose or leave the battery pack near a heat source such as fire or heater.
iii. Do not connect the anode and cathode with wire or other metal objects, which will cause the
short circuit.
iv. Do not transport or store the battery together with necklace, hairpin or other metal objects.
v. Do not strike or throw the battery pack; keep it away from mechanical shock.
vi. Do not pierce the shell of the battery pack with nail or other sharp objects. Do not hammer
or hit the battery pack.
vii. Do not disassemble or modify the battery pack, which may cause an electric shock.
67
1 LED
2 LED
3 LED
4 LED