Adjustments; Legrests; Fixed Legrests - Invacare XLT Power U-front Service Manual

Tools: 4 mm Allen Key
10 mm fixed spanner
Tools: 5 mm Allen Key
Tools: 5 mm Allen Key
10

Adjustments

FIXED LEGRESTS

C
A

LEGRESTS

It is important to adjust the footbow, footrests, leg-
rests, footplates and calf pads to obtain a good sea-
ting position
Height adjustment, footbow
Loosen the screws using an Allen key, remove them,
and adjust the footbow to the correct height. Retigh-
ten the screws and adjust the calf-strap.
The distance between the lowest part of the
footrest and the floor or ground must be at
least 40 mm.
High mounted footbow
Loosen the screws using an Allen key and adjust the
clamp and footbow to a suitable height. Retighten the
screws and adjust the calf-strap.
Height adjustment
Adjust the height of the footrests by loosening the
screw (A) one half turn with an Allen key. When
adjusting the height a clicking sound will occur. One
"click" is one step in height. Pull the legrest until
you have obtained the correct height and the screw
is caught by one of the recesses on the legrest tube.
Then retighten screw.
NOTE! Do not adjust the upper screw (C).
The distance between the lowest part of the
footrest and the floor or ground must be at
least 40 mm.
INVACARE XLT Service Manual
®