Footboard Adjustments- Depth/Height/Angle - Invacare Storm Series Service Manual

Rwd/mwd/fwd
Hide thumbs Also See for Storm Series:
Table of Contents

Advertisement

PROCEDURE 17
9. Adjust angle of footrest. Refer to FOOTREST ANGLE
ADJUSTMENTS in this procedure of the Manual.
10. Install the seat. Refer to REMOVING/INSTALLING
F
THE SEAT FRAME in PROCEDURE 6 of this manual.
W
D
11. Install NEW front shroud and existing rear shroud.
Refer to REMOVING/INSTALLING THE REAR
W
SHROUD and REMOVING/INSTALLING THE
H
FRONT SHROUD in this procedure of the Manual.
E
E
12. Install the two (2) end caps provided into the ends of
L
the seat frame where the telescoping front rigging sup-
C
ports were mounted.
H
13. Adjust footboard. Refer to DEPTH/HEIGHT/ANGLE
A
ADJUSTMENT in this procedure of the manual.
I
R
S
Mounting
Screw (STEP 6)
FIGURE 14 - INSTALLING 90
All manuals and user guides at all-guides.com
Mounting
Screws
(STEP 7)
Washer
o
90
Footrest
Support
o
90
Footboard
Flat Screws
Washers
Locknuts
o
FOOTBOARD
102
FOOTBOARD ADJUSTMENTS-
DEPTH/HEIGHT/ANGLE
(FIGURE 15)
WARNING
DO NOT remove detent pin from footrest
assembly. Otherwise, injury may result.
Depth
1. Remove the four (4) flat screws, washers and locknuts
o
that secure 90
footboard to the two (2) half clamps.
NOTE: Observe the angle of the footboard for reinstallation.
2. Move footboard to one (1) of two (2) mounting positions.
3. Secure the footboard to the half clamps with the four
(4) flat screws, washers and locknuts. Securely tighten.
Angle
1. Loosen, but do not remove the four (4) flat screws,
washers and locknuts that secure the footplate to the
half clamps.
o
2. Position the 90
footboard to the desired angle.
3. Retighten four (4) flat screws, washers and locknuts.
Height
1. Remove the two (2) hub caps.
2. Remove the mounting screw, washers, caplug
washers, and locknut that secure the footboard to
the footrest support.
3. Adjust footboard to desired height.
4. Secure the footboard with the mounting screw,
washers, caplug washers, and locknut. Tighten
mounting screw and locknut to 12 foot pounds. See
FIGURE 15 for hardware orientation.
FWD WHEELCHAIRS

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storm torque spStorm ranger xStorm arrow

Table of Contents