Table of Contents
Advertisement
120 VOLT, 50/60 CYCLE MACHINES
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This
product is equipped with a cord having an equipment-ground-
ing conductor and grounding plug. The plug must be inserted
into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of elec-
tric shock. Check with a qualified electrician
or service person if you are in doubt as to
whether the outlet is properly grounded. Do
not modify the plug provided with the product -
if it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
This product is for use on a nominal 120 volt circuit and has a
grounding attachment plug that looks like the plug illustrated in
Fig. 1. Make sure that the product is connected to an outlet
having the same configuration as the plug. No adaptor should
be used with this product.
For maximum protection against electric shock, use a circuit
that is protected by a ground fault circuit interrupter. The green
(or green and yellow) conductor in the cord is the ground wire.
Never connect this wire to any terminal other than the ground
terminal.
WARNING:
To prevent possible electric shock, protect
the machine from rain. Keep the machine
in a dry building.
WARNING:
To prevent possible electric shock, always
use a 3-wire electrical system connected
to the electrical ground. For maximum pro-
tection against electrical shock, use a cir-
cuit that is protected by a ground fault cir-
cuit interrupter. Consult your electrical
contractor.
WARNING:
Do not cut, remove or break the ground
pin. If the outlet does not fit the plug, con-
sult your electrical contractor.
WARNING:
Have worn, cut, or damaged cords and
plugs replaced by an authorized service
person.
EXTENSION CORDS
Use only an approved extension cord with three conductors, a
plug with three terminals, and a connector body with three holes.
The machine has a power cord with wire size 14 AWG (AWG
means American Wire Gauge).
WARNING:
If you use an extension cord, use an exten-
sion cord with minimum wire size 14 AWG.
Do not use an extension cord longer than
50 feet. Do not join two extension cords.
Page -6-
Grounded
Outlet
Grounding
Pin
CLARKE TECHNOLOGY Operator's Manual -Vision 17E 115V
Figure 1
Advertisement
Table of Contents
