Shutting Down The Machine; How To Clean A Very Dirty Floor - Alto Vision 17 Operator's Manual

HOW TO OPERATE THE MACHINE (cont'd)
8. To turn the machine, push the rear of the
machine to the side opposite the direction you
want to turn. It is NOT RECOMMENDED that
you move the machine backward during a
cleaning operation.
9. When you make more passes across the
floor, let the brush clean approximately 2
inches of the area already cleaned by the last
pass.
NOTE: During most cleaning procedures, apply
and remove the solution in one operation.

Shutting Down the Machine

To shut down the machine, follow this procedure:
1. Turn solution flow "Off" by turning the knob all
the way to the left (counter clockwise).
2. Lift the squeegee up by lifting up on the
handle and locking it into the "UP" position.
3. Press the bottom of the vacuum switch to
turn the vacuum "Off".
4. Press the bottom of the brush switch to turn
"off" the brush motor.
5. Raise the brush up by pushing down on the
brush lift lever with your foot sliding the lever
to the right.
NOTE: The brush may spin off the drive
adapter if the brush switch is turned ON or OFF
while the brush is in the raised position.

How to Clean a Very Dirty Floor

To clean a very dirty floor, follow this procedure:
1. Put water and cleaning chemical into the solution
tank.
2. Activate the flow of solution by turning the
solution control knob to the right and move the
machine in a straight and steady direction. You
are not removing the solution in this pass.
3. After the solution has set on the floor long enough
to start cleaning, repeat the pass with the
squeegee in the lowered position.
4. If the floor remains dirty, repeat the passes
following the steps outlined in "Operating the
Machine".
Page -14- CLARKE TECHNOLOGY Operator's Manual -Vision 17E 115V