Maintenance; Procedures Before Work Is Began - Alto Vision 17 Operator's Manual

MAINTENANCE

DANGER: Maintenance and repairs
performed by unauthorized
personnel could result in
damage or injury. Mainte-
nance and repairs must be
done by authorized Clarke
personnel only.
DANGER: Operating a machine that is
not completely or fully as-
sembled could result in injury
or property damage. Do not
operate this machine until it is
completely assembled.
Inspect the machine carefully
before operation. Keep all
fasteners tight.
DANGER: Electrocution could occur if
maintenance and repairs are
performed on a unit that is not
properly disconnected from
the power source. Always
disconnect the power supply
before attempting any mainte-
nance or service.
WARNING: Attempting maintenance and
or repairs to this machine
before emptying the solution
or recovery tank could result
in machine or property dam-
age.
Procedures Before Work is Begun
Keep the machine clean. It will need fewer repairs and
have a longer life.
1. Check power cord and plug for frayed or dam-
aged wires or missing terminal or plug.
2. Make sure the recovery tank cover is in place.
3. Check the solution tank screen and clean if
necessary. See Figure #16.
4. Make sure the vacuum screen is clean and in
position in the front of the recovery tank. See
Figure #17.
5. Make sure the solution and recovery drain hoses
are in position on the back of the machine. See
figure #18. Secure the hose drain plugs.
CLARKE TECHNOLOGY Operator's Manual - Vision 17E 115V
Figure #16
Figure #17
Page -15-