Jumpers - Konica Minolta KN-304 Service Manual

HOME

Jumpers

OP2: Reset
This allows you to restore the default values of the parameters set up before shipment.
You can reset the KN-304 normally by using MAP/browser from the computer via the network.
If you cannot use the method of using MAP/browser, perform the following procedure.
1. Turn off the printer (7020) and then remove the KN-304 from the IP-011.
2. Set the jumper OP2 as illustrated below. Connect the KN-304 to the IP-011 printer. And
turn on the printer.
3. Turn off the printer, remove the KN-304, and move the jumper OP2 to the position where it
was set initially.
4. Connect the KN-304 to the IP-011 printer, and turn on the printer.
Caution:
• If grounding is not made securely, the cards can be damaged during work. Make
sure to ground your body securely by using a wrist strap before starting to work.
• Don't move any jumpers other than OP2.
The KN-304 will restore the default settings in about 5 minutes.
ON
OP7
OP5
ON DL1
OP4
OP3
DL2
OP2
BYPASS
OP6
TEST OP1
ON
OP7
OP5
ON DL1
OP4
OP3
DL2
OP2
BYPASS
OP6
TEST OP1
Now the system is ready to operate.
Chapter 4 Appendices
4-3 KN-304 Network Board