Mounting Optional Module Expanders - Fire-Lite The Sensiscan 200 Installation, Operation, And Programming Manual

Figure 3-4: Mounting Module Expanders
Module
Step 1:
Attach four standoffs to the
module using the four
screws provided.
Figure 3-5: Mounting L-Series Expansion Modules
L-Series Module Module
For Module Installation:
Attach four standoffs to the module using
the four screws provided. Attach L-Series
Module to standoffs using mounting holes.
Secure the assembly with four nuts and
lock washers.
Expander
Module
Step 2:
Insert the pins on the expander board
into the connector on the module and
press the two boards together, ensur-
ing that the pins are properly aligned.
L-Series Module
For Expander/Module Combination:
Attach the L-Series Module to the Expander/Mod-
ule combination using the four standoffs provided.
Secure the entire assembly with four nuts and lock
washers.
S200 15032 Rev C 02/22/96 P/N 15032:C
Expander/Module
Step 3:
Secure the module/expander
assembly with four nuts and
lock washers.
This arrangement will fit in
the right most position only.
Note: L-Series modules
should not be mounted be-
hind other L-Series mod-
ules.
Expander/Module
17