Appendix B: Canadian Requirements - Fire-Lite The Sensiscan 200 Installation, Operation, And Programming Manual

Note for Canadian installations:
Canadian installation require the use of modified modules
and annunciators used for supervisory zones. Modified
modules have the red LED covered up so illumination of
the red LED under supervisory condition will not be visible
to the user. For more information, refer to the "Addendum
for Canadian Requirements for Supervisory Signals,"
Document 50056.
Operation
The Trouble LED (yellow) will flash at one of two rates to distinguish between trouble and supervisory conditions.
Supervisory – fast flash (approximately 160 pulses per minute).
Trouble condition – slower flash (approximately 60 pulses per minute).
Acknowledging the control panel will silence the audible tone and change flashing LEDs to steady operation.
64
Appendix B:
Canadian Requirements
for Supervisory Zones
S200 15032 Rev C 02/22/96 P/N 15032:C
Red LED
Yellow LED
covered by label
Initiating
Zone
Supervisory
Zone