Configuring Static Route - ZyXEL Communications P-660R-F1 series User Manual

Chapter 10 Static Route

10.2 Configuring Static Route

Click Advanced > Static Route to open the Static Route screen.
Figure 86 Static Route
The following table describes the labels in this screen.
Table 53 Static Route
LABEL
#
Active
Name
Destination
Gateway
Subnet Mask
Modify
142
DESCRIPTION
This is the number of an individual static route.
Select the check box to activate this static route. Otherwise, clear the check box.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the
same network segment as the device's LAN or WAN port. The gateway helps
forward packets to their destinations.
This is the IP subnet mask.
Click the Edit icon to go to the screen where you can set up a static route on the
ZyXEL Device.
Click the Delete icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.
P-660R-F1 Series User's Guide