13.3 Telnet
You can configure your ZyXEL Device for remote Telnet access as shown next. The administrator
uses Telnet from a computer on a remote network to access the ZyXEL Device.
Figure 99 Telnet Configuration on a TCP/IP Network
13.4 Configuring Telnet
Click Advanced > Remote MGMT > Telnet tab to display the screen as shown.
Figure 100 Remote Management: Telnet
The following table describes the labels in this screen.
Table 62 Remote Management: Telnet
LABEL
Port
Access Status
Secured Client IP A secured client is a "trusted" computer that is allowed to communicate with the
P-660R-F1 Series User's Guide
DESCRIPTION
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify
to access the ZyXEL Device using this service.
Chapter 13 Remote Management Configuration
167