SOYO SY-KT400 Dragon Ultra User Manual page 115

To be able to use the RAID function, please do the
following:
1. Connect the 2 Hard disk on IDE3/4. Set it as master.
2. Enable the RAID function in the BIOS
3. Create a Disk Array. For create instructions see below.
4. Install HPT 372 driver; check chapter 6 for driver installation
Note:
•
You can disable the HPT372 controller in the BIOS setup.
•
To boot from the HPT372 controller, (IDE 3 or IDE 4) go to
the BIOS setup and set the First Boot device to SCSI.
•
When setting up the RAID 0 or RAID 1, please use the IDE 3
master and IDE4 master. We do not recommend configuring
the RAID array on the same IDE.
You can create a disk array using:
1.
HPT372 BIOS Utility Configuration
Need to use this utility if you plan to install an operating
system on IDE3/4
2.
Highpoint ATA RAID Management software
Recommend using this software if you already have an
existing operating system in IDE1/2
Create a Disk Array
110