Troubleshooting; No Sound Is Heard; The Sound Is Out Of Sync With The Tv; Remote Does Not Work - Orbitsound M10LX Handbook

Troubleshooting

No sound is heard

• Check power connections and that there is a continuous blue light on
control panel.
• Check that the TV or other sound source is playing and that it is connected
properly to the soundbar. If unsure that your media device is playing,
unplug, and test with headphones.
• Press the sound source button on the remote control or control panel to
change the sound source. The indicators show which source is playing.
• Adjust the volume of the soundbar until sound is heard.
• Increase the volume of the playback device. The M10LX features an energy
saving mode that cuts the power to the amplifiers when there is no signal for
a long time.

The sound is out of sync with the TV

• Make sure all video sources are connected to the TV and that the soundbar
is connected to the TV optical output or RCA output sockets. This
connection method should re-align the sound. If it is still out of sync, look for
a sound/time alignment menu in the TV menus.

Remote does not work

• Check that plastic strip in remote (battery compartment) has been removed.
• If the remote has had a lot of use, replace the battery.
• Check there are no obstructions between the remote and the front of the
soundbar.

Sound is distorted

• Turn down the output of the device playing into the soundbar
• Turn up the master volume on the soundbar if necessary.
• Check that all audio connections are well seated / plugged in fully.

Sound is noisy / 'hissy'

• Turn down the volume of the soundbar unit
• Turn up the output volume of music source to compensate.
14