Prepare The Evaporator For Mounting - Harbor Point HF-25GW Installation, Operation And Maintanance Manual

HARBOR POINT WALL SPLIT DUCTLESS SYSTEMS

Prepare the evaporator for mounting

by removing the mounting bracket from
the rear of the indoor unit. Use a Phillips
head screwdriver to remove the unit pipe
strap. If the unit is a heat pump the de-
frost sensor also must be undone from its
retainer.
If mounting the unit on an outside wall
measure from the edges of the unit to the
center of the line set 90° bend to locate the
the center of the wall penetration. Drill a
3" ø hole through the wall. Angle the wall
penetration slightly down towards the out-
side to assist in draining the condensate
away from the unit.
knockout
mounting
bracket
on wall
INDOOR UNIT INSTALLATION
remove mounting bracket
Note: Prepare all wiring and piping
connections before hanging the unit
on the mounting bracket.
If mounting the unit on an inside wall, use
the knockouts provided on the left and
right sides of the unit to route the piping
and wiring connections through.
The indoor unit weighs a maximum of
20 Lbs. Use wall anchors to secure the
mounting bracket to a wall stud and en-
sure that the wall is capable of holding the
weight of the unit.
Be sure mounting bracket is level, so that
the condensate can drain properly.
7
knockout
3" ø hole