Harbor Point HF-25GW Installation, Operation And Maintanance Manual page 28

OPERATION SECTION FOR
Remote Control Operation
Note: Wait 3 minutes before restarting the unit.
Selecting MODE of OPERATION
To select operating mode, point the remote control
toward the indoor air conditioning unit:
1) Press the ON/OFF
2) Press the MODE
operating modes:
AUTO MODE – automatically operates the sys-
tem in DRY, COOL ,or HEAT mode depending on
the indoor temperature and setting.
COOL MODE – operates the system in COOL
mode depending on the indoor temperature and set
point.
DRY MODE – operates the system in DEHUMIDI-
FICATION mode.
HEAT MODE – operates the system in HEAT
mode depending on the indoor temperature and set
point.
Important:
Heating operation will cease at approximately
15° F outdoor temperature due to a sensor lo-
cated in the outdoor unit. This product does not
contain supplemental electric heat, therefore
other means of heat need to used when this sys-
tem ceases operation at low outdoor ambients.
FAN MODE – runs the FAN to circulate the air.
3) Press the ON/OFF button again to STOP.
HF-51/HF-70 & HFR-51/HFR-70
button to START.
button to step through the
28