Harbor Point HF-25GW Installation, Operation And Maintanance Manual page 31

OPERATION SECTION FOR
Remote Control Operation
clock button
Back
Press
slide
cover
down to
remove
Press
to set
hours
Press
SLEEP
button
HF-51/HF-70 & HFR-51/HFR-70
Setting the time
flashing
When batteries are inserted, the time will
automatically be set to 12:00 AM.
Front
1) With the back cover off, press the CLK
2) Press the HOUR button to change the
3) Press the MIN button to change the min-
4) When time is set press the CLK button
Note: The timer is set on basis of the time on
Press to set
minutes the clock. Be sure to set the clock correctly.
Sleep mode
Sleep mode will reduce operation sounds
when sleeping.
1) Press the SLEEP button to activate this
feature (air flow sound from the indoor unit
is decreased).
2) Press the SLEEP button again to release
the sleep mode or press the FAN SPEED
button during the SLEEP mode, and the
SLEEP mode is released
Note: Use the sleep mode when you are
going to bed. If this mode is used during the
Press
day, the capacity is reduced since the ambi-
FAN
ent temperature is higher. (COOL mode is
SPEED
recommended for day use)
button
31
button with the tip of a ball pen, etc. The
time indicator will flash, the time can now
be set.
hour. Example: (Set to 10:AM ) see front
view.
utes.
again. Slide the cover back, be sure it's
clicked securely into place.