To Operate Safely; Description Of Controls; Operating Procedures; To Operate The Dispenser - Ugolini ARCTIC COMPACT Service Manual

contact opening is at least 3 mm. Do not use extension cords.
ATTENTION
Failure to provide proper electrical ground according to
applicable electrical codes could result in serious shock
hazard.
7 The unit doesn't come presanitized from the factory. Before
serving products, the dispenser must be disassembled, clea-
ned and sanitized according to this handbook instructions
(chapter 5.3 CLEANING AND SANITAZING PROCEDURES).
IMPORTANT
Install the dispenser so that the plug is easily accessi-
ble.

4 TO OPERATE SAFELY

1 Do not operate the dispenser without reading this opera-
tor's manual.
2 Do not operate the dispenser unless it is properly groun-
ded.
3 Do not use extension cords to connect the dispenser.
4 Do not operate the dispenser unless all panels are restrai-
ned with screws.
5 Do not obstruct air intake and discharge openings: 15 cm
(6") minimum air space all around the dispenser.
6 Do not put objects or fingers in panels louvers and faucet
outlet.
7 Do not remove bowls, augers and panels for cleaning or
routine maintenance unless the dispenser is disconnected from
its power source.
ATTENTION
In case of damages, the power cord must be replaced by
qualified personnel only in order to prevent any shock
hazard.
8 This unit is not meant to be used outside.
9 This unit is not to be installed in areas subject to water-
spouts..
10 Do not use water-jets to clean the unit.
11 This unit can work in a room temperature range between
+5° and +32°C.

5 OPERATING PROCEDURES

1 Clean and sanitize the unit according to the instructions in
this manual. See chapter 5.3 CLEANING AND SANITIZING
PROCEDURES.
2 Fill the bowls with product to the maximum level mark. Do
not overfill.
The exact quantity of product (expressed as liters and gallons)
is shown by marks on the bowl.
3 In case of products to be diluted with water, potable water,
pour water into bowl first, then add correct quantity of product.
In case of natural squashes, it is advisable to strain them, in
order to prevent pulps from obstructing the faucet outlet.
4 Install the covers and check that they are correctly placed
over the bowls.
5 Set
the control

5.1 DESCRIPTION OF CONTROLS.

6 The dispenser must always run with the covers installed to
prevent a possible contamination of the product.
7 Always leave the dispenser on, as the refrigeration stops
automatically when the beverage reaches the dispensing tem-
perature. The mixing devices will continue to turn.
8 To maintain a high standard of flavour, keep refrigeration
and mixing devices on during the night when beverage is in the
bowl.
IMPORTANT
Operate the dispenser with food products only.
9 On Arctic Deluxe series machines equipped with lighted top
covers it is necessary to turn the cover for 180 degrees to
switch light off. (see figure 1)
5. 1 DESCRIPTION OF CONTROLS
The dispenser is equipped with a power switch and each bowl is
operated by a mixing device switch.
Their functions are as follows:
Power switch
0 position
I position
Mixing device switch (Arctic Deluxe series only)
0 position
I position

To operate the dispenser

1 Set power switch to I position.
2 Set mixing device switch(es) to I position.
11
switches as shown in
figure 1
: Power is turned OFF to all
functions.
On Arctic Deluxe series this
position operates the fan
: motor and makes the mixing
devices suitable to be turned
on by relevant switches.
On arctic Compact series this
p o s i t i o n o p e r a t e s a l l t h e
funtions of the dispenser.
: OFF.
: Mixing device runs.
chapter