Paper Size Label - Canon im2020 Setup Instructions

I Adjusting the Paper Reference Position (2)
4348U010AA
4348U011AA
4002U106AA
4002U105AA
4348-7743-03
1. Press the Paper Descent button and then
slide out the drawer from the Large Capacity
Cabinet.
2. Open the Right Door.
3. Loosen the adjusting screw and turn screw D
clockwise or counterclockwise as necessary.
NOTE
Use care not to damage or dent the paper
path surface inside the Right Door.
• If width A is greater than the specified value,
turn screw D counterclockwise.
• If width A is smaller than the specified value,
turn screw D clockwise.
9218
I Installing the Ornamental Cover
4348U010AA
4348U050AA
I Affixing the Paper Size Label
4348U007AA
– 7 –
4. Let the copier produce another test print and
check for the good paper reference position.
5. Make the adjustment until the specified
reference position is achieved.
6. Press the Panel Reset key to recall the Tech.
Rep. Mode to the screen.
7. Touch "Exit" on the Tech. Rep. Mode screen
to go back to the initial screen
1. Press the Paper Descent button and then
slide out the drawer from the Large Capacity
Cabinet.
2. Install the Ornamental Cover attached to the
copier (two screws).
3. Slide the drawer back in.
1. Affix the Paper Size Label furnished with the
Large Capacity Cabinet to the location
shown in the illustration.