Table of Contents
Advertisement
■ Checking for Registration
20mm
1166U014AA
4344U021AA
1166U015AA
4344-7741-01
1. Prepare a test chart (A3) as shown.
*
Draw a straight reference line at a point 20
mm from the rear edge and another at a
point 20 mm from the top edge of the chart.
2. Load the test chart in the ADF and make a
full-size copy.
3. Check that the margins reproduced on the
copy meet the following specifications.
Margin Registration Specifications:
Width A: 20 ± 2.0 mm
Width B: 20 ± 3.0 mm
If the margins reproduced on the copy fall
outside the specified range, make the
"Registration Adjustment."
9210
■ Adjusting Registration
4348P005CB
4348P005CB
4348P011CB
4344P004CA
– 7 –
1. Call the Tech. Rep. Mode to the screen.
(See the Service Manual for the procedure.)
2. Touch "Tech. Rep. Choice."
3. Touch "Sheet-through-ADF."
4. Touch "Feed (CD)" or "Feed (FD)."
Advertisement
Table of Contents
