Check - MOTO GUZZI V750 IE Workshop Manual

ENGINE
4.8.2.

CHECK

•
First check for superficial scoring and then check wear
of the cylinder bore surfaces using a dial gauge
•
Measure the inside diameter of the cylinder bore at
three different heights then turn the dial gauge through
90° and repeat the measurements; the dial gauge must
be first zero set on a ring gauge.
Key:
st
1. 1 measurement
nd
2.
2 measurement
rd
3. 3 measurement
4.
control dimension for selection
•
Check the piston diameter at the specified height and
on an axis perpendicular to the gudgeon pin.
•
Selection values refer to the bare piston (without
graphite facing).
4 - 66
V750 IE