GE Profile PSB42LSRBV Technical Service Manual page 31

To replace the water valve:
Note: Some water may leak from the
water supply line and valve when they are
disconnected.
1. Shut off the water supply to the unit.
2. Open the machine compartment and remove
the grille panel.
3. Remove the single Phillips-head screw that
holds the water valve in place.
4. Disconnect the wiring harness connector and
3 water lines from the water valve.
To replace the chilled water tank:
Note: Some water may leak from the
water supply line and valve when they are
disconnected.
1. Shut off the water supply to the unit.
2. Remove the 2 Phillips-head screws from the
chilled water tank.
3. Cut the water lines leaving enough line to
reconnect. Use 2 unions (
# WR02X10471.
Chilled Water Tank
5 5
/ -in. x / -in.), part
16 16
Screws
Approximate water temperature by the glass:
• Room Ambient at 76°F (24°C).
• 8-ounce glass.
• One-minute interval between dispensing
water.
1st glass 53°F 12°C 5th glass 66°F 19°C
2nd glass 48°F 9°C
3rd glass 52°F 11°C 7th glass 71°F 22°C
4th glass 57°F 14°C 8th glass 73°F 23°C
– 31 –
6th glass 69°F 21°C