Lamp - Christie DS+60 User Manual

5.2 Lamps
Projector Delayed on
Power Up
Powered Up, But No
Light On The Wall
Lamp Operation Mode
Didn't Change
5.3 Ethernet
013-100149-02 Rev. 1 (01/07)
2. The video input may not be terminated. Make sure the video input is terminated
(75 Ω ). If it is the last connection in a loop-through chain, the video input should
be terminated at the last source input only.
3. The input signal and/or signal cables carrying the input signal may be of poor
quality.
4. If the distance between the input source device and the projector is greater than 25
feet, signal amplification/conditioning may be required.
5. If the source is a VCR or off-air broadcast, detail may be set too high.
For more information on lamp operation modes and auto-switching, refer to Section 3
– 3.7 The Lamp Menu.
1. The projector enforces a 90 second delay between powering down and up again,
because a hot lamp is more difficult to ignite. NOTE: It can potentially take 2
minutes to cool a lamp sufficiently enough before re-striking it.
1. It takes 25 seconds for the projector to power up and strike a lamp. One of the
inherent properties of the lamp is that it may not strike with the first attempt. The
projector will wait 90 seconds before trying to strike the lamp again. It will try a
total of three times (4.5 minutes total) before it declares the lamp as "Failed to
Strike" – check
LAMP STATUS
2. Make sure the shutter is OPEN.
1. Did you request a lamp operation mode change during power up? The projector
will ignore any commands sent during initialization. Wait for "ON" to appear in
the LED status display window before entering a command.
2. Check the status of the lamp. The lamp operation mode will not change if there is
a lamp with an associated failure or lamp is not installed.
3. Make sure you have allowed enough time for the projector to turn a lamp on. This
can take up to 4.5 minutes, as the projector will strike a lamp up to 3 times
waiting 90 seconds in between each attempt. Only after a lamp is successfully
turned on will the lamp operation mode change.
1. Make sure the Ethernet settings are valid for your site—all network devices
should have the same subnet mask and unique IP addresses.
2. Make sure to save any address change, and re-boot to implement.
3. If you still have trouble establishing communications with a projector added to an
existing Ethernet network, the projector's IP address is likely in conflict with
another address already in use. Contact your network administrator.
.
Christie DS+60/DW30/Matrix 3000 User's Manual
Section 5: Troubleshooting
5-3