System Integration - Christie DS+60 User Manual

The GPIO connector located on the input panel provides a flexible method of interfacing a wide range
of external I/O devices to the projector. There are 7 GIO pins available on the 9pin D-Sub GPIO
connector, which are configurable via RS232 commands. The other two pins are reserved for ground
and power – see table below for pin identification.
GPIO
1 2 3 4 5
6 7 8 9
The serial cable required for connecting the external device to the projector's GPIO connector,
whether it's a standard serial cable or a custom one, must be compatible with the external device.
Configuring the GPIO
The GPIO connector can be configured to automate any number of events using the serial command
code GIO. Each pin is defined as either an input or output depending on the desired outcome. In
general, configure the pin as an input if you want the projector to respond to something the device
does and as an output if you want the external device to respond to an action taken by the projector.
For example, configure the pin as an output if you want the lighting in a room to automatically dim
when the projector is turned on.
By using the GIO command, you can also set the state of each pin as high or low. By default, the
state of each pin is high. The voltage applied to pins in the high state is + 3.3V.
Example 1. Turn room lighting on when the projector is turned off. (Assumes a control/automation
unit is configured to turn the lights on when pin 2 of it's input goes high.)
(GIO C2 O)
(GIO 2 H)

System Integration

Pin #
1
2
3
4
5
6
7
8
9
Set pin #2 configuration to output
Set pin #2 to high (state)
Christie DS+60/DW30/Matrix 3000 User's Manual
Appendix E
GPIO Pins
Signal
+ 12V (200mA)
GPIO 1
GPIO 2
GPIO 3
Ground
GPIO 4
GPIO 5
GPIO 6
GPIO 7
E-1