Preliminary Steps; Quick Install Steps (Tcp/Ip Protocol) - Olivetti DP Technical Information Manual

Windows NT 4.0 Network
Windows NT 4.0
Network

Preliminary Steps

Quick Install Steps
(TCP/IP Protocol)
4-16 DP Technical Information Guide
Your printer can be installed on a Windows NT network using one
of three methods:
• TCP/IP protocol
• DLC/LLC protocol
• AppleTalk protocol
The Preliminary Steps given below must be accomplished for all
printers regardless of the protocol that is being used. Then, the
Quick Install Steps will detail the installation based on the protocol
used on your network.
Connect appropriate cabling from printer to network.
1
2 Print the Configuration Sheet. Details are in the section "Print the
Configuration Sheet" (page 2-11). Retain this sheet for reference.
3 Proceed to the Quick Install Steps for your network protocol.
At the Desktop, right mouse click the Network Neighborhood icon
1
and select Properties.
Click on the Protocols tab and verify that the TCP/IP protocol has
2
been loaded.
3 Select the Services tab and verify that "Microsoft TCP/IP Printing"
is loaded.
If this software is not present, install it using the documentation
4
provided by Microsoft. Then return to this document.
Open the Control Panel and double-click the Printers icon.
5
Double-click Add Printer.
6
7 The Add printer Wizard starts.
Verify that My Computer is selected and click Next>.
8
Click Add Port.
9
From the list that appears select LPR Port.
10
11 Click New Port.