Motion Recording - Digimerge D300 SERIES Installation Manual

SECTION 4
3. SETUP ALARM:
sub-menus for Alarm and Sensors.
Press the
highlight, and press the SEL button
to access the Alarm Submenu. Use
the and
cameras to be associated to each
alarm:
4. SETUP SENSOR: Configuration
for any Sensors attached to the
Alarm block. Press the
buttons to highlight, and press the
SEL button to access the Sensor
Submenu. Use the
the Sensor type: NO (Normally
Open), NC (Normally Closed) or
None.
5. SAVE & EXIT: Saves any changes
made, and exits to the Main Menu.
Press the
highlight, and press the SEL button
to accept the changes.

Motion Recording

Setup and configurations for Motion Sensor events.
Motion Recording
NOTE: The number of cameras, alarms and sensors
displayed on submenus will change based on the
Model of DVR: 4, 8 or 16 Cameras are available.
Revision 1.0
Configuration
and buttons to
to choose the
and
and to set
and buttons to
CH/
CH1
CH2
CH3
CH4
PostMotion: 150 sec.
Setup Motion
Save & Exit
1 2
Alarm 1:
3 4
Alarm 2:
5 6
Alarm 3:
Alarm 4: 7 8
Setup Sensor
Save & Exit
FPS/ QUALITY
8 HIGH
8 MID
8 LOW
7 LOW
Recording Set
Page: 1:
CH1:
YES
CH2:
YES
CH3:
NO
CH4:
NO
Save & Exit
Sensor 1:
None
Sensor 2:
None
Sensor 3:
NC
Sensor 4:
NO
Alarm Out:
Off
Save & Exit
CH/ AREA/ SENSE
CH1 AREA HIGH
CH2 AREA MID
CH3 AREA LOW
CH4 AREA OFF
Save & Exit
31